Is There a Class of Armored Cruisers in the U.S. Navy’s Future? (Part Four)

Is There a Class of Armored Cruisers in the U.S. Navy’s Future?

 

CARN class jpeg

Sketch by Jan Musil. Hand drawn on quarter-inch graph paper. Each square equals twenty by twenty feet.

This article, the fourth of the series, presents a suggestion on how to incorporate the new railgun technology into the fleet in an efficient and effective manner. Railguns, when used as a complement to the various UAVs, UUVs and Fire Scouts discussed earlier will provide the fleet with a potent AAW weapon. Read Part One, Part Two, Part Three.

Interestingly enough, the most important piece of information concerning the new railgun is a number. A single round of ammunition costs $10,000. Eighteen inches of railroad tie shaped steel (which costs less than $200) fitted with the wonders of modern microelectronics provides a startling contrast with the $1M+ cost of the missiles the Navy currently uses against incoming aircraft and missiles. A contrast that is even more in the Navy’s favor since any future opponent will be spending comparable sums for their attack missiles and substantially more for hypersonic cruise missiles.

There are no explosives purchased with the $10,000. This means hundreds of rounds of railroad ties and microelectronics can be safely stored in a ship’s magazine. This is a substantial advantage compared to the VLS missiles in current use by navies around the globe, most of which require specialized loading facilities to reload their missile tubes. In contrast, a railgun-equipped ship can take a much larger ammunition load to sea with it, and reload the magazine at sea if necessary.

The next relevant parameter of the new railgun is its range. At 65 miles this is far less than many long-range missiles, though still quite useful against incoming aircraft and missiles. Note that with an ISR drone or Hawkeye providing over-the-horizon targeting information, a surface ship equipped with a railgun can shoot down incoming aircraft such as the Russian Bear (Tu-95) reconnaissance aircraft before the intruder can lock in on the firing ship. The same is true for any attacking aircraft carrying long-range strike missiles.

This highlights the importance to both sides of providing accurate targeting information first. It also means, strategically, at its heart the railgun in the 21st century maritime environment is a defensive weapon: well positioned to provide defensive fire against incoming attacks, but with an offensive punch limited to sixty-five miles.

That said, with the ability to fire every five seconds the railgun can be very effective, particularly when utilized in quantity when escorting carrier strike groups or when placed between a hostile shore and an ARG.

So far we have noted the positive distinguishing capabilities of the railgun but there are three significant difficulties that come with fielding the weapon. Foremost is the enormous amount of electrical power discharged by the gun when firing. This means any ship equipped with a railgun needs substantial electric power generating capabilities, something certainly beyond the abilities of the DDGs and CCGs currently in the fleet.

Secondly, using these vast amounts of electricity means a large capacitor needs to be located on the deck below the railgun. Large does mean large in this application. No little white pieces of ceramic plugged into a circuit board will do here. The necessary equipment is physically massive and in need of protection from the elements. They will be taking up a substantial amount of space just below the main deck where the railgun has to be mounted, probably one per gun.

The third problem is that all the energy dissipated in launching a round generates heat. Lots and lots of it. Most, but not all, of the energy used to launch the eighteen inches of steel will be recovered back into the ships capacitor, but enough will be lost that the launching rails flexing as the railgun is fired simply must be exposed to the elements so the heat will dissipate in the air. No sailors or flammables nearby please.

The inevitable follow up conclusion means a railgun equipped ship is going to be impossible to hide from opponent’s infrared sensors. Regardless of how stealthy versus radar the ship is, all of that heat is going to stand out like the sun itself to incoming aircraft and missiles equipped with infrared targeting systems, which means it is almost a certainty the firing ship is going to get hit if subjected to a seriously prosecuted attack.

Armor

This ship is not going to be able to hide in a cloud of chaff, it will be heading into the incoming missile strike, placing its full broadside in a position to fire and it will be considered a high priority target.

Unlike almost all naval ships built across the globe since the end of WW2, this class needs to be built with the assumption that incoming missiles will hit it, the plural is intentional, and be able to survive the multiple collections of missile slag and burning fuel and the occasional warhead detonation. Just as we built the 44 gun class of frigates back in the 1780s to be thick hulled in order to survive the gunnery practices of the time, armored up the ironclads of the Civil War and multiple classes of ships intended for the main battle line of the last half of the 19th Century and first half of the 20th Century, we need to built this class to ‘take a licking and keep on ticking’.

Topside armor should cover most of the ship, but the prime purpose of this armor will be to shed missile slag, i.e. what is left of the incoming missile after being intercepted and its fuel. The impact of the metal missile parts is not the prime danger to be protected against here. It is the fuel, and the accompanying fires after impact that is the true danger. So the topside armor needs to keep the slag and fuel on the outside of the ship, hopefully allowing gravity to carry much of the burning fuel to the gunnels and overboard; in the process vastly easing the firefighting teams job in putting out any fires that have started.

Additional armor, probably using a combination of layered materials and empty space, is appropriate for selected topside compartments that need to be protected against a successful missile warhead detonation. Whether it is sailors or equipment that is being protected, only some compartments will need beefed up exterior armor.

After that the CARN (cruiser gun armor, nuclear powered) will need to adapt the principles of the ‘armored citadel’ concepts developed a century ago for battleships to the needs of securing the two, possibly three, nuclear reactors aboard and their associated pumps and other equipment. Whether this is best done with one internal armor layer or two will keep the engineers debating for quite a while as the CARN is designed.

CARN Equipment

So what should the new 25k+ ton armored cruiser have aboard? Nuclear propulsion is an unavoidable necessity given the enormous amounts of power each railgun requires; every five seconds when engaged. Since the primary use of the CARN will be to accompany the fleet’s carriers to provide defensive AAW capabilities, this is actually an advantage for both strategic and tactical reasons. Depending on the amount of power twelve railguns firing broadsides will require, two or three of the standardized nuclear plants being installed in the new carriers should work just fine.

Lots of armor and nuclear power are unavoidable. The following basic list of desired equipment should provide the reader with a good idea of what the CARN should go to sea with.

12 railguns mounted in six dual mounts. In the attached sketch A and B mounts are placed forward of the bridge while C, D, E and F mounts are located starting roughly amidships and extend back to the helicopter deck. Dual mounts are suggested since the large size of the capacitors that need to be located directly below each railgun will in practice utilize the full 120 feet of beam provided. Obviously if the capacitors are even larger than this, then single mounts will have to be employed. Let’s hope not as doubling up makes for a much more efficient ship class.

36 VLS tubes capable of a varying load out of ASW, SM-2, SM-6 and long-range strike missiles as the mission at hand calls for.

4 CIWS with one located in the bow, a pair port and starboard amidships and one aft, just behind F mount.

12 rolling missile launchers for close in defense. It will be no secret the CARN is in the task force so a substantial number of the incoming missiles will be using infrared targeting, either in place of, or as a supplement to radar. So adding half dozen rolling missile packs to port and another half a dozen to starboard will provide plenty of localized missile defenses for both the CARN and the task force as whole.

2 ISR drones if VTOL capable. None if VTOL capability is not available

2 Seahawk helicopters

This suggested list very deliberately reduces the VLS and ASW capabilities aboard to a bare minimum. Good ship design concentrates on the primary mission the class needs to accomplish. In the case of the CARN that is absolutely, positively AAW.

In the next article we will examine how adding UAVs, UUVs, Fire Scouts, buoys and railguns in quantity to the fleet can substantially enhance the Navy’s ability to survive in the increasingly hostile A2AD world of the 21st Century. Read Part Five here.

Jan Musil is a Vietnam era Navy veteran, disenchanted ex-corporate middle manager and long time entrepreneur currently working as an author of science fiction novels. He is also a long-standing student of navies in general, post-1930 ship construction thinking, design hopes versus actual results and fleet composition debates of the twentieth century.

CIMSEC content is and always will be free; consider a voluntary monthly donation to offset our operational costs. As always, it is your support and patronage that have allowed us to build this community – and we are incredibly grateful.

Select a Donation Option (USD)

Enter Donation Amount (USD)

4 thoughts on “Is There a Class of Armored Cruisers in the U.S. Navy’s Future? (Part Four)”

  1. What sort of armor would be required? Modern supersonic (and probably now hypersonic) cruise missiles have even more kinetic energy than 16 inch battleship shells and are targetable, thus making armor thickness and placement crucial to success in improving survivability.

  2. This article, based upon the proposal for the 25+ thousand ton CARN (cruiser gun armor, nuclear powered), by the Center for International Maritime Security (CIMSEC) is nothing short of a very ambitious pipe dream. The U.S. Navy had to scuttle the CG(X) — new cruiser program, because of the enormous costs involved in building such a ship. Now CIMSEC proposes building the CARN, which would be ridiculously expensive to build, and which the U.S. Navy COULD NEVER afford to build. Such an enormous ship with so many onboard weapons and required nuclear propulsion could easily cost at least $10 Billion per copy.

    The referenced CIMSEC article points out three (3) technical problems that the CARN would have, if it were to be built. The first problem involves the huge amount of electricity that would be required to power the proposed 12 railguns on this Goliath of a cruiser. Of course, the ship would have to be nuclear-powered. At one time, the U.S. Navy had nine (9) nuclear-powered, guided missile cruisers (CGNs), and I served on two of them. Now the U.S. Navy has none. Reason being, the CGNs were too expensive to operate. It requires a substantial number of highly skilled nuclear power field Sailors, whose nuclear power program lasts about two (2) years. And then they need even more training and experience once they are assigned to a nuclear-powered ship.

    The second problem the CIMSEC article identifies is the need for a huge capacitor located on the deck below the railgun. That would take away main passage spaces for the crew (an even bigger problem during General Quarters) and would interfere with other required equipment on the ship.
    And the third identified problem is all of the heat the railgun would create A LOT of heat, much of which that would be transferred to the launching rails each time the railgun are fired. That would cause an enormous heat signature, which would be impossible to hide from opposing line-of-sight ships. And the article did not address the amount of cooling time from the elements the railguns would need after each round of ammunition (railroad tie shaped chunks of steel).

    There are other problems with the CARN that the author of the CIMSEC article did not address. The primary one is the degree of recoil that would be generated each time a railgun were fired. If it is a significant degree of recoil, it could easily cause the onboard nuclear reactors to scram (automatically shut down by going into safety mode, due to the significant jolt that could be transferred throughout the ship).
    Moreover, if the CARN were operating in bad weather and heavy seas, it very likely would not be able to launch the onboard various UAVs, UUVs and Fire Scouts (the Fire Scout is a UAV helicopter). And having UAVs loitering around the intended target ship would be absolutely essential, in order to send back vital real time information, such as whether or not the projectile hit the intended target, and if not, how far off and where did it miss the ship. Not to mention the fact that the various UAVs, UUVs and Fire Scouts would be high priority targets by the opposing ship(s).

    To conclude, the CARN WILL NEVER BE BUILT, because it would be far too expensive to build and would have to overcome some very crucial technical and architectural challenges. But it is a nice pipe dream.

  3. This is a viable future of US Navy’s surface combatants. Railguns are the future and the sooner we start tinkering with it, the better. We are already ahead of our adversaries i this department and we should invest more money in it since the benefits of a rail gun equipped cruisers outweigh the problems (technical and financial). Although the guy above me (John) said it would be to costly and US Navy could never afford it, I disagree. Yes, maybe in the start this class would be expensive, maybe even 10 billions a pop but if we take the price of missiles vs railgun slugs and the strategic value of such a platform, i think we would benefit financially by building them. Anyway, this is the future and some sort of railgun equipped ships will sail the seas very soon. Ir doesn’t have to be 12 railgun super cruiser, it could be a destroyer with 1-2 railguns that doesn’t have to be nuclear at all.

  4. its funny to go from gun in the 40’s to missles and then back to guns. This rail gun was created out of politics because the Navy CNO at the time wanted to retire the Battleships because he did not like them. They could have been updated.
    Saw an articlre that it would take the Navy said 710 milliom dollars to update each ship. Meanwhile they spent 4,7 billion on the Zumwalt and the others will cost 2,4 or 5 billion apiece. Could have recommissioned all the Battleships for the cost of onwe.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.